CAB-2 Di-Acro was designed specifically for the Di-Acro #6 and #8 Power Benders. This control was designed to be a "bolt on" kit that requires no modification to the original Di-Acro bender.
CAB-2 Di-Acro provides programmable bend angles and eliminates the need for the manually adjusted "rod stops" that originally shipped with the benders. This means that your operators will spend less time setting up the bender for various jobs and more time bending parts. Scrapped material is greatly reduced as well.
Manual angle stops are eliminated, and bend angle adjustment is no longer a matter of time-consuming trial and error.
Bend angles can be programmed to .1 of a degree. A high resolution optical encoder is used to feedback bend angle degrees to the control.
Since bend angle adjustment is no longer a matter of trial and error, your material scrap rate will decrease significantly. The Springback test routine and calculator can also be used to reduce scrap.
Plain language menus allow for quick and easy operation. No numeric codes are required.
